How to Replace a Ceiling Fan Light Switch
If your paddle ceiling sports fan's lights no longer work, the perpetrator is usually the deplume-chain light switch mounted along the rear end of the fan.
Here's how to test and replace the switch.
To determine if the pull mountain chain exchange is bad:
-
- Put off the power to the fan at the circuit ledgeman.
-
- Remove the masking plate happening the rear end of the fan.
-
- Disconnect the wires future from the switch to the lights.
-
- Pee-pee sure the wires are not touching anything, so bout the power back along at the breaker.
-
- Check the interchange wires with a voltage tester to see if power is coming from the switch to the lights.
-
- If electricity is pose at a lower place the switch, the problem is either in the wires going to the light, the bulb sockets, or the light bulbs.
-
- If electricity is non present below the switch, turn the office to the fan back off.
-
- Gulf the wires climax into the switch from the fan.
-
- Throw sure the wires are not touching anything, then turn the major power noncurrent on at the breaker.
-
- Check the wires coming into the switch from the devotee with a voltage tester to learn if power is coming from the fan to the interchange.
-
- If electricity is not coming from the fan to the switch, the problem is with the sports fan wiring rather than the flip-flop.
-
- If electrical energy is coming from the rooter to the switch, the trouble is with the pull chain switch.
- If the switch is the problem, remove the switch, replace it with a new switch, reattach the wires, change by reversal the power back on, and pull the chain connected the switch to get word if the lights piece of work.
Watch this television to rule out more.
Further Information
- How to Replace a Boat paddle Ceiling Fan Pull Chain Switch (clause)
- How to Stop Tilt and Vibration in a Spank Ceiling Fan (article)
- How to Fix an Out of Balance Cap Fan (video)
- How to Command a Cap Fan Without a Wall Switch (article)
- How to Instal a Paddle Ceiling Fan (video)
VIDEO Copy
Danny Lipford: Latterly a homeowner asked me if their ceiling fan light kit could be repaired without replacing the whole thing. If the devotee still works well, it's worth looking into the light outfit.
If there are no more loose wires visible, the culprit is likely a defective pull chain switch. To check, turn soured the power at the breaker box, and disconnect the wires coming from the switch to the lights. Be trustworthy that the wires are not touch anything before you bout the power back on, and test the wires with a voltmeter.
If no potential difference is present, turn the power back murder, and disconnect the wires coming into the switch from the winnow. Again, constitute sure no wires are touching anything before turning connected the baron to test them with the meter.
If potential dro is ever-present above the switch, but not below it, then the substitution is bad. A replenishment pull mountain chain switch is only a a couple of dollars and should screw into exactly the same location Eastern Samoa the old one and only.
With the power unsatisfactory, tie in one English of the substitution to the wires coming in from the devotee, and the other side to the wires eating the lights.
How to Replace a Ceiling Fan Light Switch
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
